Allflex AFX-100 Manual de usuario descargar pdf (Pagina 23)

Power Management

The RS420 uses a 7.4VDC – 2600mAh Li-Ion rechargeable battery pack, which serves as its

primary power source. This feature adds hours of scans with a fully charged battery.

Alternately, the reader can be powered and used indoors only by the following methods:

1. From its AC Adapter. Once the external AC adapter is connected, the reader is

powered-up, it will remain on until the AC adapter is disconnected and the Battery

Pack is charged. The reader can be powered regardless of the charge state of the

Battery Pack. The AC Adapter can be used as a power source even if the Battery Pack

has been removed from the device. If the AC Adapter has been connected, the user

may proceed with configuration and performance testing while the Battery Pack is

charging. This configuration could affect reading performances.

2. From its DC power supply cable with alligator clips

: You can connect your reader to

any DC power supply (between minimum 12V DC and maximum 28V DC) such as a

car, truck, tractor, or battery (see picture below). The reader is connected through the

socket located on the back of the reader data-power cable as shown in step 2 (see

chapter “Getting Started”).

Connect the black alligator clip to the negative terminal

(-). Connect the red alligator clip to the positive terminal

(+).

Not proposed for sale in Europe

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 31 32

Sin comentarios

Allflex AFX-100 Manual de usuario Pagina 23